A modern take on a beloved classic, the SuperStroke Zenergy Pistol GT Putter Grip merges a pistol-style top section that locks in the upper hand position with “No Taper Technology” to maintain even grip pressure. All of the new Zenergy grips include SuperStroke’s new Spyne Technology. Spyne consists of a heavily embossed ridge along the underside of the grip that guides golfers to a repeatable hand placement. Consequently, it is significantly easier to square the face at impact and make a more consistent stroke, leading to putts that start online.
SuperStroke Zenergy Pistol GT 2.0 Putter Grips – Feature:
- Pistol top section locks in the upper hand
- Traxion Control advanced surface texture with “X-Shaped” treads in high sensory areas on the sides and bottom of the grip for enhanced feel, comfort, feedback, and tack
- No Taper Technology minimizes grip pressure with a unique parallel design; uniform lower hand profile quiets the hands and adds consistency to the putting stroke
- Spyne Technology is a heavily embossed ridge on the underside of the grip that provides repeatable hand placement and a square face at impact
- Tech-Port accepts all SuperStroke accessories, including the CounterCore weight system that counter-balances the putter
- Dimensions: 10.50″ Length x 1.32″ Width
- Weight: 51g
- Core: 0.58″
- Authorised SuperStroke Retailer
+FREE GRIP TAPE INCLUDED WITH EACH GRIP
STEP-BY-STEP REGRIPPING INSTRUCTIONS
The following supplies are needed:
1.PRO-GRIP DOUBLE SIDED GRIP TAPE
2.STANLEY KNIFE / BLADE
3.NEW GOLF GRIP
4.SOLVENT WHITE SPIRITS
5.RUBBER GLOVES TO PROTECT HANDS
6. TOWEL / CLOTH
STEP 1 – Remove the old grip with a Stanley blade Be sure to cut away from
yourself at all times. Peel or scrape off the old grip and grip tape.
Using a cloth and Mineral Spirits Grip Solvent, clean off the residue.
*If removing a grip from a graphite shaft be careful to avoid damage to the shaft
STEP 2 – Wrap your PRO-GRIP double sided grip tape in a spiral formation from
the top of the shaft to the point where the bottom of the grip will be on the shaft.
Remove the tape backing and cover the end of the shaft with extra tape.
STEP 3 – Cover the vent hole in the butt end with your finger or golf tee, and pour
a generous portion of Solvent such as white spirits inside the new grip. Close the
open end of the grip with your hand and shake to cover the entire inside of the grip.
STEP 4 – Pour the excess Mineral Spirits Grip Solvent (through the vent hole)
over the entire length of the two-sided tape. Apply generously. Use a tray to
catch excess Mineral Spirits Grip Solvent for use on other clubs.
STEP 5 – Place the grip over the shaft butt and Push the grip entirely onto
the club. Be sure to push it all the way down and align the grip as desired.
This must be done while the grip tape is still wet.
STEP 6 – Allow grips to dry for several hours before playing.
Powered by Autify Digital Ltd
